Filter
Top Products
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 91
53-1002373-02
Installing a Brocade MLXe-16 router
2
You can install up the three Brocade MLXe-16 routers in a standard 19-inch (EIA310-D) rack.
If you are installing your Brocade MLXe-16 router in a cabinet or 4-post rack, refer to “” on
page 146.
Front- or mid-mount in a standard rack
Follow these steps to mount a Brocade MLXe-16 router in a rack.
You will need to provide standard #12-24 pan-head screws to mount each router in a rack. You will
need a Phillips screwdriver to perform this task.
NOTE
When connecting the device to the rack frame, use thread-forming screws and paint-piercing
washers.
1. Determine the position of each router in the rack. For example, place routers with the fewest
modules near the top of the rack, routers with more modules near the middle of the rack, and
fully populated routers near the bottom of the rack.
2. Position four mounting screws for each router using the spacing of the keyhole slots (the ones
with the narrow portion pointing up) on the mounting brackets as a guide, as shown in
Figure 58. When tightening the mounting screws, leave approximately 1/4 inch of clearance
between the back of the screw head and the rack posts.
FIGURE 58 Positioning the mounting screws in the rack posts
3. Starting with the router that will be in the lowest position in the rack, mount the router in the
rack as shown in Figure 59. With two or more people lifting the router, slip the wide portion of
each keyhole slot over the corresponding mounting screw in the rack post.
1 Unequal flange equipment rack 2 Network equipment rack
5"
3"
1 2