Filter
Top Products
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 167
53-1002373-02
Installing a Brocade MLX-8 router
3
FIGURE 119 Mounting the router in a rack (front-mount configuration)
4. Slide the router down so that the screw heads are in the narrowest part of the keyhole slots.
5. Tighten the screws to secure the router in place. For extra support, use additional screws.
NOTE
For better grounding of the router to the rack, attach the router using star washers. You should also
use star washers with any single-hole grounding lugs to keep the lugs from rotating.
Repeat step 2 through step 6 to mount each router in the rack, moving from lowest to highest.
Installing Brocade MLX-8 modules
The Brocade MLX-8 router ships with the required switch fabric modules installed.
The sequence for installing multiple modules is important to ensure proper fit. The recommended
sequence for the Brocade MLX-8 router is to install right-to-left, beginning with the lowest row and
moving up.
Installation instructions are identical for interface, management, and switch fabric modules. You
can install modules while the router is powered on and running. However, for a graceful shutdown
of the links on switch fabric modules, it is recommended that you disable the switch fabric module
before removing it from the router.
For instructions about installing 100xGbE interface modules, refer to “Installing 2x100GbE
interface modules in Brocade MLX routers” on page 151.
1 Standard 19-inch rack 2 Mounting screws
1
2