Filter
Top Products
3-24
Confidential
■ Error code 84
Paper jam
■ Error code 85
Tray 1 is not installed into the machine
Error code 86
Tray 2 is not installed into the machine
Jam Rear
Open the Back Cover and remove the jammed paper, then press Start.
User Check
• Check if the paper is jammed around the opened back cover. If jammed, remove it.
Step Cause Remedy
1
Harness connection failure of relay
rear PCB ASSY.
Check the harness connection of the relay
rear PCB ASSY and reconnect it.
2
Eject actuator catching on some
position
Correct catching of the eject actuator.
3
Paper eject sensor PCB failure Check the sensor performance following
the procedure described in “Maintenance
mode 32”. If any problem occurs, replace
the relay rear PCB ASSY.
4 Main PCB failure Replace the main PCB ASSY.
No Tray
A Tray is not detected, install Tray 1.
No Tray
A Tray is not detected, install Tray 2.
User Check
• Check if the applicable tray is installed into the machine.
• Check if the paper is jammed in the applicable tray.
Step Cause Remedy
1
T1 PE/edge sensor PCB/
T2 PE/edge sensor PCB failure
Check the sensor performance following
the procedure described in “Maintenance
mode 32”. If any problem occurs, replace
the T1 PE/edge sensor PCB failure/T2 PE/
edge sensor PCB.
2
Harness connection failure of
T1 PE/edge sensor PCB/
T2 PE/edge sensor PCB.
Check the harness connection of the T1
PE/edge sensor PCB/T2 PE/edge sensor
PCB. and reconnect it.
3 Main PCB failure Replace the main PCB ASSY.
4
Connector 55533-1219 failure
(only Tray 2)
Replace the connector 55533-1219.