Filter
Top Products
Shutting down and restarting the Content Server
Cisco TelePresence Content Server 4.1 printable online
Page 103 of 121
Shutting down and restarting the Content
Server
On Content Servers equipped with an LCD panel, this can be used to shut down or restart. On
Content Servers which do not have a LCD panel, you should use a PC connected to the Content
Server serial port via a serial cable. Cisco recommends that you end all calls on the Content Server
before you shut down; otherwise the conferences may fail.
Note: If calls are in progress when the shut down occurs, the recorded conferences appear in the
Recorded conferences list but may be unusable. They can be deleted in the normal way.
LCD panel operations
Restarting the Content Server using the LCD panel
1. Make sure that the Content Server is not recording or transcoding; that is, the LCD displays
'online'.
2. Press to display the main menu.
3. Go to Commands > Restart.
4. Select Yes to confirm.
You will see the message 'Restarting' on the LCD panel.
Shutting down the Content Server using the LCD panel
1. Make sure that the Content Server is not recording or transcoding; that is, the LCD displays
'online'.
2. Press to display the main menu.
3. Go to Commands > Shutdown.
4. Select Yes to confirm.
5. The Content Server shuts down. When you see the message 'Power off' on the LCD or when
the LAN1 and HDD LEDs stop blinking, you can turn off the power using the switch at the back
of the unit.
LCD status display and button functions
online
The Content Server is ready to accept calls and transcode outputs but none are
currently in progress.
1-5 calls
Calls are in progress on the Content Server.
transcoding
The Content Server is transcoding.
Server modes
config reload
The Content Server is in Reloading Configurations mode. In Reloading Configurations
mode, the Content Server does not accept new calls.
1-5 calls (cnfg)
Calls are in progress and the Content Server is in Reloading Configurations mode.
trans (cnfg)
The Content Server is transcoding and is in Reloading Configurations mode.
idle
The TCS Wizard is running. In Idle mode, the Content Server does not accept new
calls or process new transcoding jobs.