Filter
Top Products
Shutting down and restarting the Content Server
Cisco TelePresence Content Server 4.1 printable online
Page 105 of 121
7. Make sure that the Content Server is not recording or transcoding. Then press Esc to display
Cisco TelePresence Content Server version, IP address and recording/transcoding status.
8. Use the Up or Down arrows to navigate to Commands and press Enter to select.
9. Use the Up or Down arrows to navigate to Restart and press Enter to select.
10. Close the terminal emulator session and disconnect the serial cable.
WARNING: Do not leave a terminal emulator session open after it is no longer in use. An open
session may cause issues for system operation and when restarting.
Shutting down the Content Server using a PC connected to the serial port
1. Follow steps 1-8 in the previous section.
2. Use the Up or Down arrows to navigate to Shutdown and press Enter.
3. Close the terminal emulator session and disconnect the serial cable.
Warning: Do not leave a terminal emulator session open after it is no longer in use. An open session
may cause issues for system operation and restart.
Terminal emulator session keys
Enter key
Enters Edit mode, confirms an entry.
Esc key
Returns to the previous menu, exits Edit mode without saving.
Up and Down arrow
keys
Moves between menu items, moves between values in a numerical address and
modifies numerical values.