Filter
Top Products
6-4
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 6 Configuring SDM Templates
Displaying the SDM Templates
This example shows how to configure a switch with the layer-2 template.
Switch(config)# sdm prefer layer-2
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | layer-2] privileged EXEC command to display the resource numbers
supported by the specified template.
This is an example of output from the show sdm prefer default command:
Switch# show sdm prefer default
"default" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 5K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 9K
number of directly-connected IPv4 hosts: 5K
number of indirect IPv4 routes: 4K
number of IPv4 policy based routing aces: 512
number of IPv4/MAC qos aces: 512
number of IPv4/MAC security aces: 1K
This is an example of output from the show sdm prefer layer-2 command:
Switch# show sdm prefer layer-2
"layer-2" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 8K
number of IPv4 IGMP groups: 1K
number of IPv4 multicast routes: 0
number of unicast IPv4 routes: 0
number of IPv4 policy based routing aces: 0
number of IPv4/MAC qos aces: 512
number of IPv4/MAC security aces: 1K