Filter
Top Products
35-42
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 35 Configuring IP Unicast Routing
Configuring EIGRP
Figure 35-4 EIGRP Stub Router Configuration
For more information about EIGRP stub routing, see “Configuring EIGRP Stub Routing” part of the
Cisco IOS IP Configuration Guide, Volume 2 of 3: Routing Protocols, Release 12.2 from the Cisco.com
page under Documentation > Cisco IOS Software > 12.2 Mainline > Configuration Guides.
Beginning in privileged EXEC mode, follow these steps to configure a remote or spoke router for EIGRP
stub routing:
Enter the show ip eigrp neighbor detail privileged EXEC command from the distribution router to
verify the configuration.
Host A Host B
Switch B
Switch A
Routed to WAN
Switch C
Host C
145776
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
router eigrp 1 Configure a remote or distribution router to run an EIGRP process and
enter router configuration mode.
Step 3
network network-number Associate networks with an EIGRP routing process.
Step 4
eigrp stub [receive-only | connected |
static | summary]
Configure a remote router as an EIGRP stub router. The keywords have
these meanings:
• Enter receive-only to set the router as a receive-only neighbor.
• Enter connected to advertise connected routes.
• Enter static to advertise static routes.
• Enter summary to advertise summary routes.
Step 5
end Return to privileged EXEC mode.
Step 6
show ip eigrp neighbor detail Verify that a remote router has been configured as a stub router with
EIGRP. The last line of the output shows the stub status of the remote or
spoke router.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.