Filter
Top Products
39-13
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 39 Configuring Ethernet OAM, CFM, and E-LMI
Displaying Ethernet CFM Information
To remove an IP SLAs operation, enter the no ip sla operation-number global configuration command.
Displaying Ethernet CFM Information
You can use the privileged EXEC commands in Table 39-1 to display Ethernet CFM information.
Step 11
ip sla schedule operation-number [ageout seconds]
[life {forever | seconds}] [recurring] [start-time
{hh:mm {:ss} [month day | day month] | pending |
now | after hh:mm:ss}]
Schedule the time parameters for the IP SLAs operation.
• operation-number—Enter the IP SLAs operation
number.
• (Optional) ageout seconds—Enter the number of
seconds to keep the operation in memory when it is not
actively collecting information. The range is 0 to
2073600 seconds. The default is 0 seconds.
• (Optional) life—Set the operation to run indefinitely
(forever) or for a specific number of seconds. The
range is from 0 to 2147483647. The default is 3600
seconds (1 hour)
• (Optional) recurring—Set the probe to be
automatically scheduled every day.
• (Optional) start-time—Enter the time for the
operation to begin collecting information:
–
To start at a specific time, enter the hour, minute,
second (in 24-hour notation), and day of the
month.
–
Enter pending to select no information collection
until a start time is selected.
–
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to show that the operation
should start after the entered time has elapsed.
Step 12
end Return to privileged EXEC mode.
Step 13
show ip sla configuration [operation-number] Show the configured IP SLAs operation.
Step 14
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Ta ble 39-1 Displaying CFM Information
Command Purpose
show ethernet cfm domain brief
Displays brief details about CFM maintenance domains.
show ethernet cfm errors Displays CFM continuity check error conditions logged on a device since
it was last reset or since the log was last cleared. When CFM crosscheck is
enabled, displays the results of the CFM crosscheck operation.
show ethernet cfm maintenance-points local Displays maintenance points configured on a device.
show ethernet cfm maintenance-points remote
[detail | domain | level]
Displays information about a remote maintenance point domains or levels or
details in the CFM database.