Filter
Top Products
12-3
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-06
Chapter 12 Configuring Private VLANs
Understanding Private VLANs
• Isolated—An isolated port is a host port that belongs to an isolated secondary VLAN. It has
complete Layer 2 separation from other ports within the same private VLAN, except for the
promiscuous ports. Private VLANs block all traffic to isolated ports except traffic from promiscuous
ports. Traffic received from an isolated port is forwarded only to promiscuous ports.
• Community—A community port is a host port that belongs to a community secondary VLAN.
Community ports communicate with other ports in the same community VLAN and with
promiscuous ports. These interfaces are isolated at Layer 2 from all other interfaces in other
communities and from isolated ports within their private VLAN. No more than eight UNIs and ENIs
can be community ports in the same community VLAN.
Note Trunk ports carry traffic from regular VLANs and also from primary, isolated, and community VLANs.
Primary and secondary VLANs have these characteristics:
• Primary VLAN—A private VLAN has only one primary VLAN. Every port in a private VLAN is a
member of the primary VLAN. The primary VLAN carries unidirectional traffic downstream from
the promiscuous ports to the (isolated and community) host ports and to other promiscuous ports.
• Isolated VLAN —A private VLAN has only one isolated VLAN. An isolated VLAN is a secondary
VLAN that carries unidirectional traffic upstream from the hosts toward the promiscuous ports and
the gateway.
• Community VLAN—A community VLAN is a secondary VLAN that carries upstream traffic from
the community ports to the promiscuous port gateways and to other host ports in the same
community. You can configure multiple community VLANs in a private VLAN. Each community
VLAN can include a combination of no more than eight UNIs and ENIs.
Note The switch also supports UNI-ENI isolated VLANs and UNI-ENI community VLANs. When a VLAN
is created, it is by default a UNI-ENI isolated VLAN. Traffic is not switched among UNIs and ENIs on
a switch that belong to a UNI-ENI isolated VLAN. For more information on UNI-ENI VLANs, see
Chapter 11, “Configuring VLANs.”
A promiscuous port can serve only one primary VLAN, one isolated VLAN, and multiple community
VLANs. Layer 3 gateways are typically connected to the switch through a promiscuous port. With a
promiscuous port, you can connect a wide range of devices as access points to a private VLAN. For
example, you can use a promiscuous port to monitor or back up all the private-VLAN servers from an
administration workstation.
In a switched environment, you can assign an individual private VLAN and associated IP subnet to each
individual or common group of end stations. The end stations need to communicate only with a default
gateway to communicate outside the private VLAN.
You can use private VLANs to control access to end stations in these ways:
• Configure selected interfaces connected to end stations as isolated ports to prevent any
communication at Layer 2. For example, if the end stations are servers, this configuration prevents
Layer 2 communication between the servers.
• Configure NNIs connected to default gateways and selected end stations (for example, backup
servers) as promiscuous ports to allow all end stations access to a default gateway.