Filter
Top Products
9-8
Cisco WAN Modeling Tools Guide
OL-10426-01, Rev. A0
Chapter 9 Configuration Extraction Tool
Remote CET Extracts
Remote CET Extracts
If you wish to obtain a CET extract from a CWM or SV+ Informix database located on another
workstation, you may not need to install NMT or CET on the remote platform. You may be able to issue
the svp2cet command on your workstation and return the data from the remote platform to your
workstation.
A remote CET extract is possible only in the following circumstances:
• You must know the hostname of the remote host. You may need to know the IP address of the remote
host.
• Your local host workstation must be able to access the remote host. That is, you must be able to
successfully ping the remote host, either by hostname or by IP address, from your local host.
Symptom
The following error message is displayed:
DB not found.
Console file from the svp2cet command shows some queries and then
SQL error 802
Probable Causes
The CWM is a newer version than NMT, and has tables or fields that NMT
does not recognize.
Solution
Upgrade NMT to a later version that supports that version of CWM.
Symptom
The cet2nmt command displays the following error:
REXX: Service not available
Probable Causes
The command ran out of memory.
Solution
Reconfigure your system to use more swap space on disk.
Symptom
The %UTIL values extracted are bad.
Probable Causes
You are using CWM 9.2.09 and do not have patch 10 applied.
Solution
Apply patch 10 to CWM.
Symptom
The CET installation says that CWM is not installed, and you know that
it is installed.
Probable Causes
The NMT version is too old for the CWM version, or the CWM is installed
in a non standard way with a different DB name.
Solution
Upgrade NMT to a later version that supports that version of CWM.