Filter
Top Products
4-25
Cisco WAN Modeling Tools Guide
OL-10426-01, Rev. A0
Chapter 4 Configuration Tables and Fields
Interface Table
Speed 0 O/H Clock speed of the access port.
Values range from
• 56 to 2048 kbps for frame relay
• 3622 to 38336 for ATM on an AUSM
on an MGX 8220 edge concentrator.
• 80000, 96000, or 353208 for ATM on
a BPX, depending on the type of port
Note
A port speed of 0 has no
effect on the speed of the
specified port.
SPEED *
Limitation: Older
devices, the
MC3810 and
FastPAD are not
supported.
*
Iftype 0 O Interface Type. Applies to MPSM
connections only.
IF *
Lines 0 O Number of T1/E1 lines in IMA
port.
IMA_L *
Frame O Number of ATM cells in IMA
Frame.
IMA_F *
EngMinBw 0 O Minimum Cell Rate in egress
(transmit) direction for the partition.
Zero value means no partitioning.
EGR_MIN_BW
EngMaxBw 0 O Maximum Cell rate in egress
(transmit) direction for the partition.
Zero value means no partitioning.
EGR_MAX_BW
MinLCN 0 O Minimum number of channels in
the PNNI partition. Zero value
means no partitioning.
MIN_LCN
MaxLCN 0 O Maximum number of channels in
the PNNI partition. Zero value
means no partitioning.
MAX_LCN
BF 0 O Booking Factor used to calculate
committed cell rate that contributes
to the interface load. Ranges are
from 1% to 200%. If 0 is specified,
the globally assigned value is used
for this connection. This applies to
PNNI connections only, and is
similar to %Util for Autoroute
connections.
BF
Partition 0 Specification of the partition that
most of the remaining fields in this
table apply to. Blank entry refers to
the whole port. AutoRoute, PNNI,
or MPLS can be specified. If
multiple MPLS partitions, MPLS2
can be used for the 2nd MPLS
partition.
PART
Table 4-12 Interface Table (Port Specific Parameters) (continued)
Field Defaults Notes Description and Comments DBF CET TPI