Filter
Top Products
CALL RTR_REJECT_TX
channel_name
is not case sensitive.
The default channel name is RTR$DEFAULT_CHANNEL.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/RETRY
/NORETRY (D)
Use /RETRY to specify the
flags
parameter as RTR_F_REJ_RETRY in the call
rtr_reject_tx( )
.
The default for value for /RETRY is /NORETRY, which causes the command
server to use the value RTR_NO_FLAGS for the
flags
parameter in the call to
rtr_reject_tx( )
.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/REASON[=reason]
/REASON=0
Use /REASON to supply a value for the
reason
parameter in the call to
rtr_reject_tx( )
.
The default for value for /REASON is 0, which causes the command server
to use the value RTR_NO_REASON for the
reason
parameter in the call to
rtr_reject_tx( )
.
Related Commands
•
CALL RTR_OPEN_CHANNEL
•
CALL RTR_ACCEPT_TX
RTR Command Line Interface 6–29