Filter
Top Products
SET TRANSACTION
/NEW_STATE
Specifies the new transaction state that selected transactions will be changed to.
This qualifier is required and new state value must be specified.
Value of
new_state
may be one of the following:
ABORT
COMMIT
DONE
EXCEPTION
Note that one cannot always change a transaction’s state from one legitimate
transaction state to another. Some state changes are not valid. The following
table shows state changes that are valid.
Table 6–19 Valid Transaction State Changes
NEW STATE
Current State COMMIT ABORT EXCEPTION DONE
SENDING YES
VOTED YES YES
COMMIT YES YES
EXCEPTION YES YES
PRI_DONE YES
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/PARTITION
/PARTITION=partition_name
Specifies the name of a partition from which all transactions are running within.
A partition name must be supplied.
Use SHOW PARTITION to view the names of the currently active partitions.
/SINCE[=date]
Selects only those transactions whose timestamp is after the specified date.
Default is the current date.
Related Commands
•
SHOW TRANSACTION
•
DUMP JOURNAL
RTR Command Line Interface 6–127