Filter
Top Products
SHOW SEGMENT
SHOW SEGMENT
Display the type and size of routing key segments.
Format
SHOW SEGMENT
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/FACILITY /FACILITY="*"
/FULL /NOFULL
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The
SHOW SEGMENT
command displays the routing key segment definitions.
The routing key
definition
is common to all servers in a facility.
The routing key specifies the data within a message sent from clients used to
route the message to a particular key range server.
The position, length and data type of each key segment is displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FACILITY
/FACILITY="*" (D)
Specifies the facility name for which information should be displayed.
By default, information is displayed for all Facilities.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
RTR Command Line Interface 6–163