Filter
Top Products
SHOW RESOURCE MANAGER (SHOW RM)
SHOW RESOURCE MANAGER (SHOW RM)
Displays resource manager instance (RM) information.
This command is available only on UNIX and Windows NT systems.
Format
SHOW RESOURCE MANAGER [resource_name]
SHOW RM [resource_name]
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/FULL /NOFULL
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The SHOW RESOURCE MANAGER command displays information for registered
RMs. This command shows information for one or more RMs registered with the
current TM.
Note
This command is available only on UNIX and Windows NT systems.
Refer to Appendix C, XA Support for support information about XA.
Parameters
resource_name
Specifies the name of the resource manager instance you want to display.
resource_name
may contain wild cards ("*" and "%"), in which case all matching
resources will be displayed. If
resource_name
is omitted all configured resources
are displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
RTR Command Line Interface 6–159