Filter
Top Products
DISPLAY BAR
Qualifiers
/AVERAGE=(keyword,...)
/NOAVERAGE
Specifies that the items being monitored relating to
keyword
are displayed as an
average. This allows a number of items to be averaged in one qualifier.
The
keyword
can be one of the following:
Keyword Meaning
NODE Node data items
LINK Link data items
FACILITY Facility data items
PROCESS Process data items
PARTITION Partition data items
FE_TRANSACTION Frontend transaction data items
TR_TRANSACTION Backend transaction data items
BE_TRANSACTION Router transaction data items
/BELL[=Boolean-expression]
/NOBELL (D)
Sends a bell character to the terminal if
Boolean-expression
evaluates to True
(non-zero).
/BLINK[=Boolean-expression]
/NOBLINK (D)
Specifies that the displayed value blinks if
Boolean-expression
evaluates to True
(non-zero).
/BLANK[=Boolean-expression]
/NOBLANK (D)
Specifies that the displayed value is replaced by blanks if
Boolean-expression
evaluates to True (non-zero).
/BOLD[=Boolean-expression]
/NOBOLD (D)
Specifies that the item is displayed in high intensity if
Boolean-expression
evaluates to True (non-zero).
/CHARACTER[=char]
/NOCHARACTER
/CHARACTER="a" (D)
Specifies the character used to draw bar charts. The line drawing character set
is used to display them. By default, the character ‘‘a’’ is used, which corresponds
to a rectangular block in the character set. If /NOCHARACTER is given then
no characters are displayed and the bar is visible only if attributes have been
specified. This can be used to draw a scale behind the bar chart.
/DAMPING[=damping-factor]
/NODAMPING (D)
Specifies that the value displayed is to fluctuate more slowly than the raw
measured value. The default for
damping-factor
is one. Damping is only
relevant if
/VALUE=CURRENT
.
6–68 RTR Command Line Interface