Filter
Top Products
MODIFY JOURNAL
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/MAXIMUM_BLOCKS[=nr-blocks]
/MAXIMUM_BLOCKS=1000 (D)
Specifies the maximum size that the journal file can use. This qualifier can be
applied locally to each disk or globally for all disks.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
Related Commands
•
CREATE JOURNAL
•
INITIALIZE JOURNAL
•
SHOW JOURNAL
OpenVMS Example
RTR> MODIFY JOURNAL DISK1$:/BLOCKS=3000/MAXIMUM_BLOCKS=20000
This command specifies that the desired size of the journal file is 3000 blocks,
and the maximum journal file size is 20,000 blocks.
Example
RTR> MODIFY JOURNAL "/dev/rz3a" /BLOCK=2000 /MAXIMUM_BLOCKS=20000
This command specifies that the desired size of the journal file is 2000 blocks,
and the maximum journal file size is 20,000 blocks.
RTR Command Line Interface 6–99