Compaq AA-Q88CE-TE Network Router User Manual


 
SHOW RTR
SHOW RTR
Display the configuration and status of RTR.
Format
SHOW RTR
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/COUNTER[=counter-name] /NOCOUNTER
/FULL /NOFULL
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
/STATUS /NOSTATUS
/VERSION /NOVERSION
Description
The
SHOW RTR
command displays the configuration and status of RTR.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the per node counters are also to be displayed.
Counter-name
is the
name of the counter to be displayed. If
counter-name
is omitted then all counters
will be displayed.
Counter-name
may contain wild card characters.
/FULL
/NOFULL (D)
Equivalent to specifying
/COUNTER/STATUS
.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
RTR Command Line Interface 6–161