DELETE FACILITY
DELETE FACILITY
Delete an RTR facility.
Format
DELETE FACILITY facility_name
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/NODE=node-list /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The
DELETE FACILITY
command removes the specified facility on the node where
the command is issued. After issuing this command applications are able to use
the facility. Any outstanding transactions using the facility are aborted.
Parameters
facility_name
The name of the facility to delete.
The parameter
facility_name
must be supplied.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
RTR Command Line Interface 6–61