Filter
Top Products
CALL RTR_REPLY_TO_CLIENT
Table 6–12 Generated Format Strings
Data Type With /LENGTH= With /NOLENGTH
STRING =n, "%nC" "%nC" where n=strlen(string)
SIGNED =1, "%SB" "%SL"
SIGNED =2, "%SW" "%SL"
SIGNED =4, "%SL" "%SL"
UNSIGNED =1, "%UB" "%SL"
UNSIGNED =2, "%UW" "%SL"
UNSIGNED =4, "%UL" "%SL"
Refer to Application Programmer’s Reference Manual, section ‘‘Defining a
Message Format Description’’ for information on constructing a
fmt-string
parameter.
/INDEPENDENT
NOINDEPENDENT
Use the /INDEPENDENT qualifier to specify the flags parameter RTR_F_ACC_
INDEPENDENT in the call to rtr_reply_to_client( ).
/LENGTH_OF_FIELD=field-length
Enter the size of the message field that you want to define. The default for string
types is the length of the message entered, plus one (for the zero termination
byte). The default for signed and unsigned types is four. This is a positional
qualifier; it must immediately follow the message field that it refers to.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/TYPE_OF_DATA=STRING| SIGNED | UNSIGNED
/TYPE_OF_DATA=STRING (D)
Enter the data type of the message field that you want to define. The default
is the string type. This is a positional qualifier; it must immediately follow the
message field that it refers to.
Related commands
•
CALL RTR_SEND_TO_SERVER
•
CALL RTR_RECEIVE_MESSAGE
RTR Command Line Interface 6–33