Filter
Top Products
SHOW FACILITY
SHOW FACILITY
Show the names, configuration and status of one or more facilities.
Format
SHOW FACILITY [facility-name]
Command Qualifiers Defaults
/BALANCE /NOBALANCE
/CLUSTER /NOCLUSTER
/CONFIGURATION /NOCONFIGURATION
/COUNTER[=counter-name] /NOCOUNTER
/FULL /NOFULL
/LINKS /NOLINKS
/STATE /NOSTATE
/OUTPUT[=file-spec] /OUTPUT=stdout
/NODE[=node-list] /NODE=default-node-list
Description
The
SHOW FACILITY
command shows the names, configuration and status of
facilities on the node where the command is executed. If no qualifiers are used,
only the facility name or names and the roles in the facility on the node are
displayed.
Parameters
facility-name
Specifies the name of the facility you want to display.
Facility-name
may contain
wild cards ("*" and "%"), in which case all matching facilities will be displayed. If
facility-name
is omitted all configured facilities are displayed.
Qualifiers
/BALANCE
/NOBALANCE (D)
Specifies that the load-balancing status of the facility is also displayed. See
Section 2.6, Router Load Balancing for details of load-balancing.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
6–136 RTR Command Line Interface