Filter
Top Products
CREATE FACILITY
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FRONTEND=frontend-list
/NOFRONTEND (D)
Frontend-list
is a list of
frontend-nodes
separated by commas. If there is more
than one
frontend-node
, then
frontend-list
must be enclosed in parentheses.
Frontend-node
is either the name of a node or
@file-spec
, where
file-spec
specifies a text file containing a
frontend-list
on each line.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/RESOURCE_MANAGER=resource-list
Specifies a list of defined resource managers that this facility may reference.
Server applications using this facility and resource manager will receive any
recovered transactions when the facility is created. See Appendix C for further
information.
/REPLY_CHECKSUM
/NOREPLY_CHECKSUM (D)
Specifies that the reply consistency check (or Response Matching) feature for
replayed messages is enabled. It is a check for reply consistency during a replay
of a reply to client message.
RTR can enable, disable and display this feature.
/ROUTER=router-list
/NOROUTER (D)
Specifies the names of the nodes that act as routers for this facility.
Router-list
is a list of
router-nodes
separated by commas. If there is more
than one
router-node
, then
router-list
must be enclosed in parentheses.
If /NOBALANCE is specified with the CREATE FACILITY command, then the
order in which router nodes are specified with the /ROUTER qualifier defines the
preferred routing order
.
Router-node
is either the name of a node or
@file-spec
, where
file-spec
specifies a text file containing a
router-list
on each line.
Related commands
•
DELETE FACILITY
•
EXTEND FACILITY
•
SHOW FACILITY
•
TRIM FACILITY
RTR Command Line Interface 6–49