Filter
Top Products
SHOW LINK
SHOW LINK
Display the configuration and status of the links to other nodes.
Format
SHOW LINK [node-name]
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/COUNTER[=counter-name] /NOCOUNTER
/FACILITY /NOFACILITY
/FULL /NOFULL
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
/STATE /NOSTATE
Description
The
SHOW LINK
command shows the configuration and status of the links to RTR
nodes. If no qualifiers are given, a brief display of the links is shown.
Parameters
node-name
Specifies the name of a node; the parameters for the link to this node are
displayed.
Node-name
may contain wild cards ("*" and "%"), in which case all
matching links will be displayed. If
node-name
is omitted all known links are
displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
/NODE
nor
/CLUSTER
is specified then the command is executed on the
nodes specified by the latest
SET ENVIRONMENT
command. If no
SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the link counters are also to be displayed.
Counter-name
is the
name of the counter to be displayed. If
counter-name
is omitted then all counters
will be displayed.
Counter-name
may contain wild card characters.
/FACILITY
/NOFACILITY (D)
Specifies that the names of facilities using the link are also displayed.
6–144 RTR Command Line Interface