Filter
Top Products
SHOW PARTITION
• The state of transaction presentation - one of active, suspended or suspending
• The current failover policy - one of fail_to_standby, fail_to_shadow or pre_
v32_compatibilty
The SHOW PARTITION comand displays callout server data as backend server
data because a callout server uses server, not router, data structures. A callout
server actually runs on the router identified for its facility.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/ROUTER
/NOROUTER (D)
Displays information about router partitions; it shows the partition state and
partition low and high bounds. It can be used to quickly determine the current
primary node for a given partition. Using /ROUTER with /FULL provides more
detailed information, such as the main, shadow and standby servers for the
partitions, as seen from the router.
Partition bounds are shown as ASCII characters if there is a translation,
otherwise as hexadecimal digits. Only the least significant four bytes are shown.
Examples
The following example shows a router partition.
RTR> SHOW PARTITION/ROUTER
Facility Low Bound High Bound Primary Main
RTR$DEFAULT_FACILITY 0 4294967295 depth
RTR> SHOW PARTITION/ROUTER/FULL
Facility: RTR$DEFAULT_FACILITY State: ACTIVE
Low Bound: 0 High Bound: 4294967295
Failover policy: fail_to_standby
Backends: depth
States: active
Primary Main: depth Shadow Main:
The following examples show two backend partitions.
RTR> SHOW PARTITION/BACKEND
Partition name Facility State
RTR$DEFAULT_PARTITION_16777217 RTR$DEFAULT_FACILITY active
RTR$DEFAULT_PARTITION_16777218 RTR$DEFAULT_FACILITY active
RTR> SHOW PARTITION/BACKEND/FULL
6–154 RTR Command Line Interface