Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers Printer User Manual


 
B-5
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
The cards cannot have a punched area closer than 0.45 in (1.14 cm) from the
right edge (as loaded in the card cartridge).
If the card has a magnetic stripe, the card cannot be punched anywhere in the
stripe.
Card quality guidelines
Your cards must meet the following card quality guidelines for the Select printer to
print high quality graphics on them successfully.
Card surface
The card surface must be free of irregularities such as particles embedded in the
surface.
The card surface must be smooth and even. Surface irregularities can cause loss
of contact, resulting in printing voids.
The printing surface must be glossy. It cannot have a matte finish (see other
sections in this appendix for more information).
Card edges must be free of raised burrs which can cause unprinted areas on
cards. This is especially ture when printing Edge-to-Edge. Burrs alond card edge
will result in printing voids.
Card handling
These guidelines apply to unprinted cards. Any debris or particles on an unprinted
card’s surface can reduce print quality and damage the printhead. Grease or oils,
such as oils from your fingers, also reduce print quality.
Keep cards completely clean.
Do not touch the print surface of a card with your fingers or hands.
Do not use a rubber band to bind blank cards together.
If you drop a card on the floor, do not insert it into the Select printer.
Card storage
These guidelines apply to both printed and unprinted cards.
Cards must be stacked so that they will not shift and rub against each other.
When storing cards, make sure that no two cards contain images or blocks of
color that will come in contact with each other.
Make sure that the magnetic stripe on one card does not come in contact with the
magnetic stripe on another card.
Make sure that cards with magnetic stripes are stored away from magnets and
other magnetic objects.