Filter
Top Products
Before you install 6-3
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
• Store all supplies in a clean, cool, dry location. See “Supply roll storage” on
page B-2 for information about the storage environment for Select supplies.
Selecting the site
After meeting general requirements, the site for the Select printer should meet the
electrical, physical, and environmental requirements of the printer. Finally, be sure to
select an appropriate site for printer supplies.
Electrical requirements
The Select printer requires the following electrical conditions for optimal performance:
• 90-254 VAC at 50/60 Hz (The Select printer automatically adjusts to any power
within this range.)
• Single phase, 3-wire grounded receptacle only
The maximum input current for the Select printer is 1.4 amps at 100 VAC applied.
Physical requirements
The Select printer requires an environment that accommodates its physical
dimensions and weight.
The printer weighs between 21 and 26.5 pounds or 9.7 and 11.9 kilograms.
The surface holding the printer might also need to bear the weight of other
equipment such as a PC and camera.
The dimensions are:
• Depth of 17.8 inches (54.1 cm) for Select models
• Depth of 24 inches (65 cm) for Select 2 models
• Width of 8.8 inches (22.2 cm)
• Height of 10 inches (25.4 cm)
The clearance required is:
• 3 inches (7.5 cm) on the left side of the printer, for access to the power switch and
for ventilation.
• 3 inches (7.5 cm) in back of the printer for ventilation and for clearance for cables.
• 10.5 inches (26.7 cm) above the printer to allow the cover to open and to change
supplies.
i