Filter
Top Products
Maintaining the printer 4-13
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
Replace the printhead cartridge
1 Carefully align the openings on the (white) power cable plug with the wires of the
power receptacle on the printhead. Push the cable’s plug all the way onto the
receptacle (see Figure 4-11).
2 Push the (gray) data cable plug into the new printhead cartridge (see Figure 4-11).
Make sure the locking tabs are in place.
Do not press on the wires of the printhead cables.
3 If the printhead has a ground cable, slide the ground cable connector onto the
ground tab of the swing arm (see Figure 4-12).
4 Align the printhead cartridge pins with the printhead cartridge slots on the swing
arm (see Figure 4-13).
5 Slide the new printhead cartridge onto the swing arm, so the pins slide into the
slots (see Figure 4-13).
Figure 4-13: Align pins with slots on the swing arm
6 Align the notches on the printhead cartridge with the notches on the spring bar (1
in Figure 4-14).
!
1
1