Filter
Top Products
177
Printing a Network Configuration Page
The Network Configuration page shows how the network interface card on your printer is
configured. The default settings are suitable for most applications.
1
Press
Setup
Machine Setup
from the home screen.
2
Press the
Next
( ) button.
3
Press the up/down arrows to select
Reports
.
4
Press the up/down arrows to select
Network Settings
.
The Network Configuration page prints out.
Setting Network Protocols
When you first install and power up the printer, all supported network protocols are enabled. If
a network protocol is enabled, the printer may actively transmit on the network even when the
protocol is not in use. This may slightly increase network traffic. To eliminate unnecessary
traffic, you may disable unused protocols.
1
Press
Setup
Machine Setup
from the home screen.
2
Press the
Next
( ) button.
3
Press the up/down arrows to select
Network Setup
.
4
Press the up/down arrows until you see the desired protocol
5
If you selected
Ethernet Speed
, select a network speed.
If you selected
TCP/IP (IPv4)
or
TCP/IP (IPv6)
, assign a TCP/IP address. For details,
see "
Configuring TCP/IP".
If you selected
EtheTalk
.
a
Press
Activate
.
b
Press the left/right arrows to change the setting to
On
(enable) or
Off
(disable).
NOTE: When you set EtheTalk, you must
restart your machine to apply new settings.
6
Press the home icon ( ) to return to the Standby mode.
Network Protocols TCP/IPv4, IPv6 (DHCP, DNS, 9100, LPR, SNMP, HTTP, IPSec),
EtherTalk, Novell NetWare NDPS services via TCP/IP & IPP on 5.x, 6.x,
DHCP, BOOTP, SLP, SSDP, Bonjour (Rendezvous), DDNS, WINS, TCP
(Port 2000), LPR (Port 515), Raw (Port 9100), SNMPv1/2/3, HTTP,
Telnet, SMTP (E-mail Notification)
Dynamic Addressing Server DHCP, BOOTP
Item Requirements