Filter
Top Products
Installing System Components 107
4
If applicable, disconnect the SAS cable connector on the expansion card.
5
Remove the system board shroud. See "Removing the System Board
Shroud" on page 71.
6
Position your thumb firmly over the socket-release lever and release the
lever from the locked position. Rotate the lever 90 degrees upward until
the processor is released from the socket. See Figure 3-20.
7
Gently lift the heat sink off of the processor and set the heat sink aside.
NOTICE: The processor is held in its socket under strong pressure. Be aware that
the release lever can spring up suddenly if not firmly grasped.