Filter
Top Products
118 Installing System Components
Replacing the Power Distribution Board
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
1
Unpack the new power distribution board assembly.
2
Position and seat the power distribution board over the four standoffs on
the chassis base, and then put the power distribution board shroud over
the power distribution board and align the standoffs with the four locator
holes on the four corners of the power distribution board shroud. See
Figure 3-23.
3
Locate, align, and install the four captive screws that seat in the holes on
the four corners of the power distribution board shroud. These captive
screws also align and seat the power distribution board and shroud in the
bay of the chassis base and the system. See Figure 3-23.
4
Connect the fan module cable connector to the power distribution board
and then put the power distribution board shroud over the power
distribution board, as shown in Figure 3-23.
5
Connect all cables to the system board, front control board, and
backplane. See "Installing the System Board Assembly" on page 121,
"Installing the Control Panel Assembly" on page 115, and "Installing the
Backplane Board" on page 102.
6
Locate the hinged interior catches on either side of the shroud and align
and seat the power distribution board cover, rotating it down and over the
shroud. See Figure 3-23.
7
Install the power supplies in the system. "Replacing a Power Supply" on
page 89.
System Board (Service-Only Procedure)
The system board and system board tray are removed and replaced as a single
assembly.