Filter
Top Products
Installing System Components 91
4
Insert the USB memory key into the USB connector onto the board. See
Figure 3-13.
5
Close the system. See "Opening and Closing the System" on page 68.
6
Reattach any peripherals, then connect the system to the electrical outlet.
7
Turn on the system and attached peripherals.
8
Enter the System Setup program and verify that the USB key has been
detected by the system. See "Entering the System Setup Program" on
page 45.
Figure 3-13. Installing an Internal USB Key
NOTE: In the preceding figure, the 12C cable is shown connecting over the control
panel cabling. This cable should be routed under the control panel cable and the
internal USB key connector. The 12C cable seats in a cable guide clip that is directly
beneath the control panel connector.
1 front control board 2 internal USB connector
3 USB memory key
321