Filter
Top Products
About Your System 35
Alert! Unsupported
memory, incomplete
sets, or unmatched
sets. The following
memory is disabled:
Unsupported DIMMs,
mismatched DIMMs, or
unmatched DIMMs have
been detected. If more
than one DIMM is
present, DIMMs must be
installed in matching
pairs.
For memory configuration
information, see "Memory
Module Installation
Guidelines" on page 102. If
the problem persists, see
"Troubleshooting System
Memory" on page 135.
Attempting to
update Remote
Configuration.
Please wait...
Remote Configuration
request has been detected
and is being processed.
Wait until the process is
complete.
BIOS Update Attempt
Failed!
Remote BIOS update
attempt failed.
Retry the BIOS update. If
problem persists, see
"Getting Help" on page 165.
Caution! NVRAM_CLR
jumper is installed
on system board.
NVRAM_CLR jumper is
installed. CMOS has been
cleared.
Remove NVRAM_CLR
jumper. See Figure 6-1 for
jumper location.
Decreasing
available memory
Faulty or improperly
installed memory
modules.
See "Troubleshooting System
Memory" on page 135.
Diskette drive 0
seek failure.
Faulty or improperly
inserted diskette,
incorrect configuration
settings in the System
Setup program, or loose
diskette/tape drive
interface cable, or loose
power cable. Replace the
diskette.
See "Troubleshooting a
Diskette Drive" on page 138.
Diskette read
failure.
Faulty diskette, faulty or
improperly connected
diskette/tape drive
interface cable, or loose
power cable.
See "Troubleshooting a
Diskette Drive" on page 138.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions