Filter
Top Products
Installing System Components 99
Figure 3-16. Installing and Removing the Riser Card
Installing the Riser Card
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1
Align the riser board with the alignment pins on the system board, then
lower the board onto the pins.
2
Press down on the riser board until the edge connector(s) on the board is
(are) fully seated in the riser board connector on the system board. See
Figure 3-16.
1 riser card release latch 2 riser card connector
3 left riser card 4 center riser card
5 riser card connector 6 center riser card alignment
pins (2)
6
3
4
12
5