Filter
Top Products
94
When the status of the program start signal is switched from OFF to ON
with the program immediately stopped, the program will resume from
the suspended step and stop at the cycle end.
Robot status
Operating
halfway
On halt
Performing
remaining
operation
Program start ON (shorted)
signal (input) OFF (open)
Instantaneous stop ON (shorted)
signal (input) OFF (open)
Single-cycle operation
Program Start Operation-3
Caution: To cancel the execution of the remaining steps of an
instantaneously stopped program and start it from the
beginning, input a program reset signal, a program No. select
signal and a program start signal at the same time. For further
information, refer to Subsection 6.4.5 "Program Reset (Input)".