25
2.4.5 User Output Commands
There are three types of user output commands, SET, RESET and OUT. The SET
and RESET commands turn ON and OFF all user outputs specified by I/O type
variables. The OUT command outputs data to a specified user output.
• SET Command
The SET command turns ON all user outputs specified by I/O type variables.
For further information about the SET command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "SET."
• RESET Command
The RESET command turns OFF all user outputs specified by I/O type variables.
For further information about the RESET command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "RESET."
• OUT Command
The OUT command outputs data to the user output specified by an I/O type variable.
For further information about the OUT command, refer to the PROGRAMMER'S
MANUAL (I), Chapter 13, Section 13.1 "OUT."