Filter
Top Products
Softing Linking Device –
Manual for Configuration, Installation and Maintenance
Linking Device FG-110 FF - Internal Web Server
page 34 of 85 V1.3
You choose the chapter for the start web side of the FG-110 FF with a click on the check box
beside the desired chapter.
When you press the button <Set Homepage> the input will be activated. The next start of the
web application will show you the selected page as your homepage. If you choose the
<Monitor><Point Monitor> you have to select the desired page. <Monitor><Point Pages>
shows you the desired page at once.
4.5.4 <Configuration><Fieldbus>
4.5.4.1 <Configuration><Fieldbus><Devices>
When you click <Configuration><Fieldbus><Devices> the table with the connected devices
to the Linking Device appears on the screen.
The table shows which segment from the Linking Device is occupied with how many devices.
The devices are indicated with their Node, their Device ID and their PD Tag.
Additionally there is information about the alarm VCR (VCR address) and the status of the
alarm (Alarm configured). When the alarm is configured ( ) then it can be used otherwise
there is a red dot ( ).
Fig 4.5-12 Change Node or PD Tag of your fieldbus devices
The fields “Node” and “PD Tag” are input fields. In a connected system, the inputs
from here have an influence on the values in the FF-CONF Program. Press the
button <Set Tag> and the changed data appears as well in the FF-CONF
Program.
The fields “Segment” and “Device ID” are only display fields. No input is possible.
4.5.4.2 <Configuration><Fieldbus><Blocks>
In this site you see the blocks of all FF-H1 field devices which are connected to the Linking
Device.
Based on a possible large number of function block there are two filters:
- Segment: 1…4
i