Filter
Top Products
Softing Linking Device –
Manual for Configuration, Installation and Maintenance
FF-CONF Configure your plant
V1.31 page 71 of 85
5.8.2.6 Changing parameters online
It is also possible to call the parameter view of all blocks of a device by selecting the device
and pressing the icon <Open parameters view> in the upper right-hand corner of the device.
Fig 5.8-9 Changing parameters online by pressing the block icon in the upper right-hand corner of the device
Now you see all the parameters of the first block (it’s the same view and processing as
explained in Function Block application). If you need to see the parameters of another block,
click the button <Block> near the top center of the displayed window. Now click the desired
parameter and you see the window Parameter Value. Choose one or more of the required
values and click the button <Set> to activate your selection.
If there is an error message displayed in the trace log view, this might be due to
the fact that the device is in AUTO mode and some of the parameters can only
be written in MANUAL or OOS (out of service). If this is the case, first set the
block to the desired mode by writing MODE_BLK.TARGET.
!