Filter
Top Products
Softing Linking Device –
Manual for Configuration, Installation and Maintenance
FF-CONF Configure your plant
page 46 of 85 V1.3
Fig 5.1-13 The changed mouse pointer allows you to move the whole configuration picture
5.1.4.2 <Function Block Application>
The tab <Function Block Application> is always active. Here you configure the
communication between the blocks of the H1 devices or the HSE Host. In Function Block
Application you can create different groups and applications to structure the whole plant and
its various areas.
5.1.4.3 Network Livelist
The Network Livelist shows you the currently active devices. To run your system it’s
necessary to assign configured and active devices of Network Configuration and Network
Livelist. How this is done is explained in detail in chapter Network Livelist.
In the Network Livelist you may sort the devices on PD Tags with the icon .
5.1.4.4 Parameter View
Parameter View shows you all parameters of each block as well as of the selected device as
of a block which is not associated with a device. You can change parameters if they are in
read/write mode.
5.1.4.5 Schedule View
Schedule View shows information about the cyclic behaviour of an H1 link. It lists all VCRs of
the LAS and the start time of the function blocks and their duration.
5.1.5 The Trace Log
Under the main view you see the partition for the Trace log. In the Trace log all information,
warnings and errors are listed while running the program. It shows the success of your
action. You can filter for each message type by activating the check box.
Here you see a screenshot with trace log after using the build function.