Softing Linking Device –
Manual for Configuration, Installation and Maintenance
FF-CONF Configure your plant
page 68 of 85 V1.3
5.8.2.3 Configure connections
Fig 5.8-4 Configure connections
Configure a connection by pressing the link buttons:
1. select output pin (H1_Device _3_PID_3.BKCAL_OUT)
2. select input pin (H1_Device _3_PID_3.FF_VAL)
3. click <connect> button
Configure your application block by block. You cannot reuse a block which has already been
used.
In each application the flow of information between the blocks will be defined (e. g. Discrete
Input, Analog Output). It is not possible to control the plausibility of the joined blocks
automatically because of the high number of individual applications. Only connections which
are technologically impossible in the system will be rejected by an error message in the trace
log or marked with a red arrow (e. g. type mismatch).
5.8.2.4 Configure parameters
To switch to the parameter view, select a block and pick the parameter view using the right
mouse button.
