Filter
Top Products
5 - 24
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
• On: The alarm message of the signal parameter selected will only appear as long as
the signal will exceed the allowed level. The alarm message will disappear, if the
value is again in the range allowed.
• On (Hold Alarm): The alarm message for the signal parameter selected will appear
after the signal will have exceeded the allowed value. The alarm message will also
keep alive, if the value will be back again in the range allowed.
To delete the message, you have to go back to the menu "Alarms Setup" with the F4
key or the ←← -key and to start the function "Acknowledge alarms !".
Options:
♦ F3 (Channel):
To change to the setup menu of the other channels
of an MLT analyzer or analyzer module.
♦ F5 (View...):
To change to the submenu "Parameter (i.e.: Concentration) Alarm Status", where you
will find the alarm status ("On/Off") of the four alarms for the parameter selected.