Emerson I-0021 Computer Accessories User Manual


 
5 - 68
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
Main Menu — Analyzer and I/O-module expert configuration
Analyzer module setup
Inputs and outputs
SIO-01 module
From the menu "Local SIO Configuration Parameters" you can change to submenus to
control and set up several output configurations of the local SIO module.
General Configuration of a SIO board (the whole specification see its own manual):
Analog outputs: minimum 2, maximum 8
Serial interface (RS 232 or RS 485) to connect the analyzer module with
an external computer
Three relay outputs
If there is a SIO module installed in the analyzer you have to put in "Enabled" in the line
"Module installed", otherwise "Disabled".
Set up parameters:
Select the line of variables or any menu line with the -key or the -key.
Select the variable or change to the submenu with the 88 -key or the -key.
Select the parameter with the -key or the -key.
Confirm the new adjustment with the 88 -key or
cancel and go back to the last value with the F2 key.
Measure
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Local SIO Configuration Parameters --
Analog output setup...
Serial interface setup...
Configuration of Relay Outputs...
Module installed: Enabled
Back...
5.1 Analyzer Module Setup
5.1.18 Inputs and Outputs – Local SIO
[2nd menu page via F5 (More...)]