Filter
Top Products
On-board IDE Drive
This option allows you to enable or disable the built-in IDE
hard disk drive controller. The default setting is Enabled.
First Serial Port Address
You can select a COMl address of 2E8H, 3E8H, 2F8H, or 3F8H.
If Programming Option is set to Auto, this option is set to
Disabled.
Second Serial Port Address
You can select a COM2 address of 2ESH, 3ESH, 2FSH, or 3FSH.
If Programming Option is set to Auto, this option is set to
Disabled.
Parallel Port Address
You can select an address of 278H, 378H, or 3BCH. If
Programming Option is set to Auto, this option is set to
Disabled.
IRQ Active State
This option allows you to set the IRQ signal High or Low to
assert the interrupt. The default setting is High.
Parallel Port Mode
This option sets the mode used by the built-in parallel port.
You can select Normal or Extended (or EPP, enhanced
bidirectional parallel port, for higher performance when you
use an EPP device). The default setting is Normal.
2-12 Running the Setup Program