Filter
Top Products
You must install a metal plate and filler panel in any
open drive slot to maintain the electromagnetic
emissions characteristics of the system and to ensure
proper cooling of the interior.
9.
If you secured the drive in the upper bay using the holes
that are the closest to the front of the computer, you must
reinstall the computer’s power switch assembly that you
removed earlier. Insert the assembly into its hole in the
computer’s front panel, making sure the two tabs on the
assembly rest on the bottom of the hole. Secure the switch
and its grounding wire with the retaining screw. See the
illustration on page 5-14.
10. To install the computer’s front bezel, align the retaining
clips inside each side of the bezel with the slots in each side
of the computer’s front panel. Be sure the LED cables on the
left side of the front panel fit inside the front bezel. Then
press in on the bezel until the retaining clips click into place.
11. Replace the 3.5-inch drive carrier in the computer; see
page 5-6.
12. Replace the computer’s cover; see Chapter 4.
13. See “Post-installation Setup” in Chapter 4 for instructions
on configuring your system with the new drive
configuration.
Installing and Removing Drives
5-15