Filter
Top Products
When you finish installing or removing drives, see
“Post-installation Setup” in Chapter 4 for instructions on
configuring your computer with your new drive(s).
Note
You may want to know the number of cylinders, heads,
sectors, etc., on your drive(s) if the AUTO-CONFIG option
in Setup cannot correctly identify your drive type. See
Chapter 2 and the documentation that came with your drive
for this information.
Setting the Hard Disk Drive Jumpers
Before you install any IDE hard disk drives, you need to check
or change the settings of the drive’s jumpers to be sure they are
set correctly for your drive configuration.
The table below lists the jumper settings for high-capacity,
optional EPSON hard disk drives. If your drive is not listed,
check the documentation that came with it or call the
manufacturer for the jumper settings.
IDE hard disk drive jumper-settings
*
CS (cable selection) can be jumpered for any configuration. When CS is
used, the drive is a master if pin 28 is grounded and a slave if pin 28 is not
grounded.
5-2 Installing and Removing Drives