Filter
Top Products
13. Turn off your system and then change the setting of jumper
J12H1 back to the normal flash operation setting. Also
change the setting of jumper J13H1 to set your CMOS
values to their default settings. See Chapter 4 for
instructions.
14. Turn on your system and verify that it boots correctly.
15. Turn off the system and change jumper J13Hl back to the
setting for normal CMOS operation.
16. Turn on your system. When you see the Setup prompt,
press F1 to run Setup and change your settings as
necessary.
Recovering an Interrupted BIOS Upgrade
If an interruption or error occurred as you were upgrading the
BIOS, follow these steps to recover your BIOS:
1.
Change the setting of jumper J12H1 to allow a flash recovery
of your BIOS. See Chapter 4 for instructions.
2.
Insert the bootable diskette containing the BIOS upgrade
and recovery utility and the new BIOS file in drive A.
3.
Turn on your system. You will not see any video display
during the rest of this procedure because of the small
amount of code available in the non-erasable boot block
area. Listen to your computer’s speaker and watch the
diskette drive access light (as described below) to monitor
the utility’s operation.
The system beeps once and the diskette drive LED lights up.
The recover operation is in progress. When it is finished
copying the recovery code, the system beeps twice and the
diskette drive access light goes out.
Using Your Computer 3-7