Filter
Top Products
Note
If your monitor supports resolutions greater than 640 x 480,
you should run the Mach32 installation program.
If you do need to run the Mach32 installation program, be sure
to do the following to make sure the program runs correctly:
Make sure no system hardware, such as fax/ modem
boards or LAN boards, use the address COM4 (2E8) or any
address in the range 2E0 to 2EF.
Check to be sure no LAN boards, scanner boards, or other
adapters are using the upper memory addresses between
C000 and C7FF.
Make a note of the amount of system memory currently
installed in your system.
Remove all commands to load memory manager device
drivers from your CONFIG.SYS file until you have installed
all the video device drivers.
Starting the Mach 32 lnstallation Program
Follow these steps to start the Mach32 installation program :
1.
Insert the AT1 Mach32 driver diskette in drive A.
2. Type A:\INSTALL and press Enter.
Using the Video Utilities
6- 7