Filter
Top Products
U s e r I n s t a l l a b l e F e a t u r e s
Li feBo ok 6 0 0 Series fr om F uji tsu
135
C A U T I O N
If you are storing the internal battery
screw the screws back into your note-
book so that they don’t get lost.
5. Push the rear edge of the battery down gently
but firmly until the battery is seated and flush
with the bottom surface of your notebook.
6. Replace the screws.
7. Turn your notebook over, attach a power
adapter, turn on your notebook and check
the Status Indicator panel to verify that the
battery is recognized and determine the
amount of charge.
To Install the Internal Lithium ion Smart
battery
1. Remove the screws of the internal battery
compartment. (Figure 4-15.)
2. Align the tabs on the battery with the
recesses on the edge of the compartment.
3. Tilt the battery toward the front of
your notebook.
4.Place the battery so that the edge near the
front of the notebook is against the bottom
of the compartment.
P O I N T
If the battery is new it will not be
charged and will require that you use a
power adapter until it is charged.
C A U T I O N
The CD-ROM drive requires the use of
a power adapter or both an internal and
external battery. It will NOT operate on
the the internal battery alone.
BASE ENHANCEMENT UNIT
The Base Enhancement Unit is very similar to
the LAN Enhancement Unit but adds fewer
additional functions to your notebook. The
Base Enhancement Unit does not support
hot-docking. Therefore, you must shut down
your notebook before docking and undocking.
Theft
Prevention
Slot
PS/2 Keyboard
Port
PS/2 Mouse
Port
MIDI/Joystick
Port
Dual USB
Port
Serial Port
Stereo Line
Out Jack
Composite
Video Jack
Parallel
Port
External
Monitor Port
DC Power
Jack
Figure 4-16 Base Enhancement Unit Rear View