Filter
Top Products
U s i n g Y o u r L i f e B o o k 6 0 0 S e r i e s
Life Bo ok 6 00 Se ries f rom F uj it su
37
other application software volume setting will
not produce sound.One easy operating method
is to use the hardware and ESS AudioRack vol-
ume controls to set an upper limit on sound
level and then make fine adjustments with
other application software.
FLOPPY DISK DRIVE
The floppy disk drive wh i ch is built-in yo u r
LAN Enhancem ent Unit is a 3.5" drive wh i ch
can re ad and wri te on 1.44MB and 720KB
m em ory capac i ty floppy disks. F l oppy disk for-
mat is con tro ll ed from your opera ting sys tem .
(See your sof twa re documen t a tion for more info r-
m a ti o n . ) You can use the opti onal ex t ernal flop-
py disk drive . The sys tem wi ll treat any floppy
disk drive in ex act ly the same way rega rdl e s s
of wh ere it is install ed . (See LAN En h a n cem en t
Unit on pa ges 103-107 and In s t a lling an Opti o n a l
External Floppy Disk Drive on pa ge 107.) Wh en
your sys tem boots it wi ll alw ays look first for
a floppy disk drive in the LAN Enhancem ent
Unit and then look at the ex ternal floppy disk
d rive port .
Loading a Floppy Disk
To load,insert a floppy disk into the floppy disk
drive,shutter side first and label up, until the
eject button, above the floppy disk drive open-
ing, pops out. (Figure 2-10)
C A U T I O N
The ESS AudioRack volume setting
sets the maximum volume level of the
hardware volume control knob.
C A U T I O N
If you use a speakerphone function,
be sure that the microphone setting in
the ESS AudioRack (recorder portion)
is disabled.
C A U T I O N
To get your system to recognize a newly
installed floppy disk drive you must
restart your notebook.
Figure 2-10 Loading/Ejecting a Floppy Disk
Eject Button