Filter
Top Products
5-93
Problem Resolution
Parameter # Description Units
152 Ink out enable. If TRUE, ink detection of the pen cartridge is in effect. If FALSE,
no ink detection will occur.
Default value = 1.
0 = FALSE
1 = TRUE
153 Send polling enable. If TRUE, HP OfficeJet Series 300 has been setup to be polled
by another fax. User selects from the Fax Setting menu.
Default value = 0.
0 = FALSE
1 = TRUE
154 Ink print enable. If TRUE, HP OfficeJet Series 300 will attempt to print even if the
print cartridge is out of ink.
Default value = 0.
0 = FALSE
1 = TRUE
155 Printer reset delay duration setting.
Default value = 1000 ms.
1000 to
10000 ms
156 ECM enabled. If TRUE, error correction mode is enabled.
Default value = 1.
0 = FALSE
1 = TRUE
157 Coding mode. Three encoding schemes are possible: MH (modified Huffman), MR
(modified read) and MMR (modified modified read). This parameter specifies
which coding scheme will be default.
Default value = 3.
1 = MH
2 = MR
3 = MRR
158 Transmit start speed. Default bits per second (BPS) rate. The speed may be
adjusted down as training occurs.
Default value = 4.
1 = 2400
2 = 4800
3 = 7200
4 = 9600
159 Maximum erred lines. When in non–error correction mode, the number of page
lines indicating an error which will be accepted before the page is rejected.
Default value = 60.
Depends on
page size
160 Benchrun execution time. Factory use only.
Default value = 0.
N/A
161 Maximum scanner doc length. Maximum length the scanner will scan for before
indicating a ”Scanner Jam” on the front panel display if the end of page was not
sensed.
Default value = 17.
1 inch (0 to
9999)
162 Auto reduction when out of memory. Amount of automatic reduction that will
occur if the entire document does not fit into HP OfficeJet Series 300 and a value
must be guessed.
Default value = 91.
1% (70 to
100)
163 FAX/Copy print scale method. Selects whether a hardware or software scaling
algorithm will be used to scale either faxes or copies.
Default value = 2.
1 = HW
2 = SW
164 Photo mode copy print scale method. Determines which algorithm will be used
when copying a document using PHOTO resolution. Suggested value is 2.
Default value = 2.
1 or 2
165 SW scaling switching threshold. For factory use only.
Default value = 999.
N/A
166 Maximum mech speed. Maximum speed at which the print mechanism will
operate in inches/sec. For factory use only.
Default value = 24 ips.
N/A