Filter
Top Products
2 - 10
5. Remove the battery.
6. Insert the new battery and apply gentle pressure to engage the latch.
Note: Make sure the stylus tether is not caught under the battery during installation.
7. Lock the battery by sliding the latch toward the battery pack.
Note: The terminal does not power ON unless the battery is locked.
8. Reattach the hand strap.
9. Press the Power key or the SCAN key to wake the terminal from Suspend Mode (see page 2-9).
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in dam-
age not covered by the warranty.
Resetting the Terminal
There are two types of system resets: a hard reset or a factory reset. The hard reset preserves all data
stored in the file system. Contact a Honeywell technical support representative for information on how to
perform a factory reset. For contact information, see Customer Support on page 15-1.
Hard Reset (Cold Boot)
A hard reset re-boots the device and closes any open applications running in RAM at the time of the
reset.
1. Press and hold the BLUE + SEND keys for approximately 10 seconds.
Or
1. Press and hold the Power key for approximately 5 seconds.
2. Tap Reboot on the Phone Options menu.
4
3
5
!